Water heaters are a huge part of a home and an appliance that needs to be maintained to ensure that it is in good working order. The water heater is exactly what it sounds like the water is heated in a tank and then used when you turn on the water in your home. The tank stays heated up and full as the water is used. The water heater is either electric or gas and will use this to ignite the light that heats up the water. The appliance should be maintained by a plumber and if you are in the market for a new one we should also be the one to install it. After you have a new appliance like a water heater installed you want to get the best out of it and ensure that it is lasts.

Orsack Plumbing Company Offers Tips to Get the Best Out of Your Water Heater After Installation

Set The Temperature Setting on Your Water Heater: The water heater is going to heat the water in the tank. That water is then sent through the plumbing fixtures and you never want to turn on the heated water and not get what you want. The tank has a setting on it that you need to set for a particular temperature. The average or standard setting is usually about 140 degrees. The water in the tank needs to be hotter than you would actually use because by the time it gets to your faucet it has cooled down a bit. The standard temperature in the unit is not necessary and you can lower it to around 120 degrees. This is a great idea for many reasons; one being someone is less likely to be scalded. The other reason is that the water heater will be more efficient and will end up saving you money.
You Want To Add Water Heater Insulation: The water heater has a large tank that is where the heated water is stored until it is needed. As the water cools off the heater will need to kick back in gear and heat the water again. One way to stop that from happening is to ensure that the water heater is insulated. You can add insulation to the unit after it was installed.
Have The Water Heater Anode Rod Cleaned: The anode rod is the pipe that is at the top of the unit. It is the pipe that will ensure that the water stays clean as it is sent into your home. You want to be sure that the pipe is in good condition. This is best done when a plumber comes out and does maintenance on the water heater.
Keep An Eye On Water Heater Expiration: When you have a water heater they may go unnoticed until there is a problem. The biggest issue is when the water heater goes out it can lead to a serious amount of water damage. That is why it is best to check the date of the water heater and make any repairs that are needed.

Water Heater Installation & More in Spring, The Woodlands, Magnolia, Montgomery & Conroe Texas

Orsack Plumbing Company offers expert plumbing services. Contact us for all your plumbing needs.